Before
AfterDriveway Cleaning — Jacksonville, FLSame surface, same day. The difference is removing organic growth rather than rinsing over it.
Concrete Driveways
Driveway Cleaning in Jacksonville, FL
Even, uniform concrete — cleaned with a surface cleaner instead of a wand, so you don't end up with stripes.
Why It Looks Like That
Why Jacksonville Driveways Turn Grey and Green
Concrete is porous. Over a few Florida summers it takes on tyre marks, engine drips, red clay tracked in from landscaping, tannin stains from oak and magnolia leaves, and a layer of algae that thrives anywhere the surface stays damp — which, near irrigation heads and under shade, is most of the time.
The result is a driveway that reads as "just old" until a section gets cleaned and the actual colour of the concrete reappears. On most Jacksonville homes the driveway is the largest single surface visible from the street, so it drives the impression of the whole property more than anything except the roof.
The technique matters as much as the pressure. Cleaning concrete freehand with a wand leaves overlapping arcs — the striped "zebra" pattern you see on DIY jobs and on work from contractors in a hurry. A rotating surface cleaner covers the slab in even, controlled passes at a consistent distance, which is the only reliable way to get a uniform finish across a whole driveway.
What We Clean
Driveway & Approach Surfaces
The driveway is rarely the only thing that needs attention — the surrounding flatwork usually shows the same wear.
Concrete driveways
Broom-finished, smooth and exposed-aggregate concrete, cleaned with a surface cleaner at the correct pressure for the finish.
Aprons & curbing
The strip between driveway and street holds the worst of the road grime and is often skipped.
Garage floors
Where oil and drips accumulate. Cleanable, though older stains may lighten rather than disappear.
Walkways & entry paths
Same concrete, same problem. See concrete cleaning.
Paver driveways
A different process entirely — joint sand has to be considered. See paver cleaning.
Parking areas
Multi-space residential parking, HOA visitor parking and small commercial lots.
Before & After
Concrete, Before and After
A shaded Jacksonville driveway with tyre marks and organic film, cleaned in even surface-cleaner passes. Swap in your own project photos from real Jacksonville jobs.
BeforeAfterOur Process
Our Driveway Cleaning Process
Pre-treat, clean evenly, rinse out. No shortcuts on the boring parts.
1
Clear and inspect
Vehicles moved, debris blown off, and existing cracks, spalling or previous sealer noted.
2
Pre-treat the growth
A cleaning solution is applied first so the algae is broken down before the surface cleaner touches it — this is what stops it returning quickly.
3
Surface clean in passes
Rotating surface cleaner in overlapping, consistent passes for an even finish across the whole slab.
4
Detail and rinse
Edges, expansion joints and curbing detailed by hand, then the whole area is rinsed clean.
Keep Exploring
Related Services
Concrete Cleaning
Sidewalks, walkways, entries and curbing on the same visit.
Learn more about Concrete Cleaning
Paver Cleaning
If your driveway is pavers rather than poured concrete.
Learn more about Paver Cleaning
Answers
Driveway Cleaning FAQs
Can you remove oil stains from concrete?
Often, to a degree. Fresh drips respond well to a dedicated degreaser and hot-water treatment. Old oil that has soaked deep into porous concrete may lighten substantially without disappearing completely — concrete absorbs, and what is below the surface cannot always be pulled back out. We will tell you honestly what to expect when we look at it rather than promising a result we cannot deliver.
How often should a driveway be cleaned in Florida?
Around once a year for most Jacksonville driveways, and more often for shaded driveways, driveways under oak canopy, or slabs that get hit by irrigation. Algae regrows fastest wherever the concrete stays damp. More on algae on Jacksonville concrete.
Will pressure washing damage my driveway?
Not at correct pressure with a surface cleaner. Damage happens when someone holds a narrow-angle tip too close to the slab, which etches lines into the surface permanently. Older or already-spalling concrete needs a lighter touch, which is part of what the pre-job inspection is for.
Should I seal my driveway after cleaning?
Sealing can help concrete resist staining and slow down how quickly organic growth takes hold, and it should only be applied to a properly cleaned, fully dry slab. If you are interested, ask about it when you request your estimate. Confirm whether you actually offer sealing before publishing this answer.
Do you clean the sidewalk and curb too?
They are usually quoted together, because cleaning a driveway and leaving a dirty walkway beside it is visibly worse than leaving both. Tell us the full area you want covered and it will be in the written scope.
Ready for a Cleaner, Brighter Exterior?
Tell us what needs cleaning and we'll get you a clear, written estimate for your Jacksonville property.